You open the swimming pool every summer, hoping to see sparkling clean water under that cover. Wait a minute... that won't happen. Well, technically, if you live in a place where you don't need to close the pool, then you will never use the cover you can set, but for the rest of us, what happens in the pool water in winter is not Pretty.
Even the best coverrs will bring some debris and dirty water from the cover to the pool water below, which is just part of the work of opening the pool. You can't swim with a lid, so you have to deal with the consequences!
In order to clean the water, you must remove all the leaves, debris and normal water from the water. Sadly, most vacuum cleaners only work when they reach the water level in a year because they use pumps but you can still dig up some larger vacuum cleaners when the water level is low. At this point [although the water is not too deep] it is also a good idea to enter and brush the walls of the pool. It is recommended that you do this when you close the pool, but if you accumulate a lot of content during the winter, you may need to do this again.
Once all the debris and dirt have flowed out of the pool, experts say that a certain degree of impact is a good way to raise the level of chemistry and eliminate any bacteria that may be lingering. The best way to use the impact is to use it when the water level returns to normal, so keep holding the hose and pump to the sink again before the hose is held down to work.
The water in the pool looks clean and clear, but that doesn't mean swimming is healthy. This is where the pool water test kit comes in handy. You should test the water once a week [test once a day if there are obvious problems] and replace the chemicals as needed. For example, too much chlorine can cause irritation to the skin and eyes during swimming. Too little and you risk the infection of bacteria, no one wants to break this pleasure.
Orignal From: Your pool water
No comments:
Post a Comment